keyword pages: 1  
< 1 of 5 >
AlexAndChristine > The finished product. The securing bolts are 1/2" and fit into T-nuts.
AlexAndChristine > Everything put together and laying sideways on the table.
AlexAndChristine > The marks left by the transfer punch. I wasn't very careful with my measuring when drilling the holes in the cap, so they aren't always centered in the V. That is just an asthetic concern, not a functional one.
AlexAndChristine > Transferring the location of the fixing holes from the cap to the base.
AlexAndChristine > This photo shows the setup for cutting the V in both the base and cap. I used an adjustable angle table (setup to 45 degrees using a 45/45/90 gauge...the angle table scale is way off) and mounted my normal vise to it. It was tedious cutting the steel block where I could only take off about 0.020" at a pass, but easy with aluminum where I could take off 0.060" at a pass.
The finished product. The securing bolts are 1/2" and fit into T-nuts.
AlexAndChristine > The finished product. The securing bolts are 1/2" and fit into T-nuts.
The finished product. The securing bolts are 1/2" and fit into T-nuts.
See photo in gallery
keyword pages: 1  
< 1 of 5 >

Comments

|

New comment:

Name: Email: Link:


To foil spammers, enter this code: copy this text in this box: Code unreadable?